Flat Pack – Overview
The Flat Packed version of our award-winning Firewood Feeder® has been designed so just one person can put it together relatively easily using a power drill or a powered screwdriver. That said, having someone to help you can certainly speed up the process and make it even easier.
So please check you have all the parts needed that are listed below. And if you any issues or questions then please contact us at support@groovytimber.com or call us on +44 (0)20 7861 4430. Thank you.
Flat Pack Package
Flat Pack – Package Contents
1 x front panel
1 x back panel
1 x sloping panel
1 x sliding & removable roof
18 x side panels (including 2 x angled roof support panels attached to 2 x top side panels)
2 x 15mm panel spacers
80 x 50mm screws
6 x 100mm screws
Flat Pack – Equipment You Need
1 x power drill or powered screwdriver
Location, Location, Location...
Unpack the Firewood Feeder® flat packed package and lay out all the constituent parts at the location where you want to place your new log store.
And, when you've stopped grinning at the prospect of putting together your new log store (which you can easily do on your own), you can get cracking and put it together!
Please now follow the easy 8-step self-assembly plan below...
Step 1
Stand up the back panel in the correct position where you want to place the log store.
Step 2
Fit the top side panels (each one is supplied with two connected panels with the one on top being an angled cut) on both sides, with the back wall being placed vertically or horizontally (whichever is easier for you), and screw into position with the supplied 50mm screws in the positions marked on the corner posts.
Please make sure you keep the top of these side panels level with the top of the back panel where it meets the top of the posts (as in the photos).
Step 3
Fit the front panel to the side boards and screw in position using the 50mm screws.
Step 4
Fit the bottom side panels on both sides and screw into position with the 50mm screws in the positions marked on the corner posts.
Step 5
Install the sloping floor and secure at the back using 2 x 100mm screws.
Step 6
Using the two 15mm spacers provided (that mark out the correct gaps between the side panels) fit the remaining side panels, screwing them into the posts using the 50mm screws.
Please remember to line up the side panels with the front and back panel pieces as an added guide.
Step 7
When this is done, slide the roof panel into position using the two vertical grooves in the top panel to help guide it into position.
Step 7 (cont..)
When this is done, slide the roof panel into position using the two vertical grooves in the top panel to help guide it into position.
Step 8
Then, when the roof is in place, secure it by screwing 2 x 100mm screws into both holes on the sides of the front posts
Step 8 (cont...)
Well done! Your Firewood Feeder® is now ready for you to use, benefit from and enjoy!